Oyaide is using holes, so if you copy them, you should get similar results, good or bad. I'd like to think they considered all that stuff?

And yes, of the metal options offered i'd say you chose wisely. If you want to dress it up, how about machine turning? You know, you take a small disc with sandpaper or polishing grit and give it a half turn, letting them overlap a bit. Leaving swirls all over it.

And if you really wanted to pitch the disc, so it is higher at the outside edge than the center, it only needs to be a millimeter or two difference? The proper way would be to actually cut the disc that way, flat on the bottom, dished on the top. To maintain contact under the disc. I'm just thinking out loud here, for the sake of conversation. It really is just great like it is! Do you use a record weight? Or clamp?


Sent from my iPad using Tapatalk