-
platter/bearing wobble?
Hi all,
i have a 1210 with a visible 'wobble' in the platter when spinning (viewed at a 45 degree angle). the deck is relatively new to me and is fitted with a mike new bearing.
I have tried to level the deck, using a round spirit level on the platter, but not had much joy. i can get it almost level at 3, 6, 9 & 12 if i keep the platter still, but if i take a 3, then check it at 6, 9 & 12 by leaving the level in the same place and spinning the platter through 90 degrees, it is way out.
this tells me the platter is flat, but the bearing is not straight - am i right, or is there something fundamental (and likely obvious) that i am missing?
how do i go about sorting it, if that is the case?
any advice welcome!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules