+ Reply to Thread
Page 1 of 2 12 LastLast
Results 1 to 10 of 12

Thread: Beautiful Pioneer SA 6300

  1. #1
    Join Date: Sep 2009

    Location: Bournemouth

    Posts: 3,980
    I'm Dan.

    Default Beautiful Pioneer SA 6300

    Hello Guys

    Just thought i would post this yesterday whilst looking online the above Pioneer came up in a free section of gumtree so an email later and a trip over to Poole this little gem was in the car and home we come Very heavy for its size and also quite rare but in need a clean "Pot" and service - tested and working.

    This is going in the collection after I've got it thoroughly checked over

    Attached Images Attached Images
    Main System: Yamaha CR-820 Receiver & Musical Fidelity E50 Tuner & Pioneer PD S505 Precision CD Player & Mission 770 Freedom Speakers + Linn Interconnects & Van Den Hul The Wind hybrid Speaker Cable
    Vinyl -
    Rega Planer 2 with Rega Britain Green 250 Tonearm & Upgraded Van Den Hul Oil Bearing & Ortofon Super OM-10.

    Second System:
    Technics - SU-C909U Pre-Amplifier & SE-A909S Power Amplifier & Technics ST-GT 1000 Tuner & Marantz CD67 Original SE CD player & Thorens TD-125 MK1 Turntable & SME 3009 Series 1 & Shure V15 Type II Cartridge & SME 2000 Plinth & Celestion A compact Speakers

  2. #2
    Join Date: Jun 2012

    Location: Portsmouth, UK

    Posts: 80
    I'm Steve.

    Default

    Nice. My flatmate used to have the SA-9300, which was an awesome and huge bit of kit.

    I found a previous generation Pioneer SX-450 receiver in a wet skip the other week. Must be late seventies. I let it dry out and IT ALL WORKS! Even the lightbulbs.

    Like you say, the switches and knobs could do with some switch spray. But they're not bad either.

    All this mystifies me slightly, because I thought those old wet electrolytic capacitors dry out eventually. So far so good.

    And soundwise, it's faultless. Here's to freebies. And BTW, no problem with newer CD level into auxiliary. I don't think CD output is actually any different from the old tape deck standards. I checked my Rotel schematic, and AUX and CD go into the same opamp.

  3. #3
    Join Date: Sep 2009

    Location: Bournemouth

    Posts: 3,980
    I'm Dan.

    Default

    Hi Steve

    I've just seen your post...

    Yes i love the older generation of Pioneer most of my HI-FI is Pioneer so i had to grab this....I have just got round to cleaning the switches & polishing the knobs & facia and shes very shiny....i'm gonna test later on this afternoon too see if it works..I have my test speakers out and ready to go....I'm very surprised that other members of the forum have not commented on this i think its a beautiful looking piece...
    Main System: Yamaha CR-820 Receiver & Musical Fidelity E50 Tuner & Pioneer PD S505 Precision CD Player & Mission 770 Freedom Speakers + Linn Interconnects & Van Den Hul The Wind hybrid Speaker Cable
    Vinyl -
    Rega Planer 2 with Rega Britain Green 250 Tonearm & Upgraded Van Den Hul Oil Bearing & Ortofon Super OM-10.

    Second System:
    Technics - SU-C909U Pre-Amplifier & SE-A909S Power Amplifier & Technics ST-GT 1000 Tuner & Marantz CD67 Original SE CD player & Thorens TD-125 MK1 Turntable & SME 3009 Series 1 & Shure V15 Type II Cartridge & SME 2000 Plinth & Celestion A compact Speakers

  4. #4
    Join Date: Feb 2014

    Location: Huntingdonshire

    Posts: 1,082
    I'm Andrew.

    Default

    I don't think the naff picture is helping Dan...

  5. #5
    Join Date: Jul 2014

    Location: Shropshire

    Posts: 1,695
    I'm Anto.

    Default

    Quote Originally Posted by agk View Post
    I don't think the naff picture is helping Dan...
    Ha ha , Nice amp Dan . The lovely grime on the power lead is a tad offputting ,but I am sure once you have buffed the little beggar up , you can find a slot in your creaking storeroom for it
    I only ride 'em, I don't know what makes 'em work

  6. #6
    Join Date: Sep 2009

    Location: Bournemouth

    Posts: 3,980
    I'm Dan.

    Default

    Well i can now update this thread and say the pot clean worked a treat they are now silent in operation and the amplifier is now - I've set up a little night system with a pair of Mini Technics SB-30 full range speakers & modded Pioneer PDS703 & Pioneer F676 Tuner and is working very well together system for peanuts and sounds this good....

    Not bad going.....
    Main System: Yamaha CR-820 Receiver & Musical Fidelity E50 Tuner & Pioneer PD S505 Precision CD Player & Mission 770 Freedom Speakers + Linn Interconnects & Van Den Hul The Wind hybrid Speaker Cable
    Vinyl -
    Rega Planer 2 with Rega Britain Green 250 Tonearm & Upgraded Van Den Hul Oil Bearing & Ortofon Super OM-10.

    Second System:
    Technics - SU-C909U Pre-Amplifier & SE-A909S Power Amplifier & Technics ST-GT 1000 Tuner & Marantz CD67 Original SE CD player & Thorens TD-125 MK1 Turntable & SME 3009 Series 1 & Shure V15 Type II Cartridge & SME 2000 Plinth & Celestion A compact Speakers

  7. #7
    Join Date: Feb 2013

    Location: W Lothian

    Posts: 34,573
    I'm Grant.

    Default

    Well done Dan.. bet it sounds good too. Good amps these
    Regards,
    Grant ....
    Sometimes incompetence is useful. It helps you keep an open mind.
    .... ..... ...... ...... ................... ..... ..... ..... ..... .....
    IMUTO TAURUS X4 BATTERY SUPPLY. - RPI2B & AUDIOPHONICS DAC running MOODE 3.7- TONBRUX BATTERY SUPPLY & CHROMECAST2 AUDIO DONGLE no1 - JBE SERIES 3 SLATEDECK & EMOTIVA XPS-1 PHONO - DENON DV2900 - TWIN PRO MONOBLOCK AMPLIFIERS. - XIANG SHENG DAC\PRE\HEADPHONE AMP. -AUDIO TECHNICA ATH-MSR7 & OPPO PM-3 PLANAR HEADPHONES - WIN10 JRIVER22, SPOTIFY PREMIUM- KINPS CABLES, SMSL M6 MINIDAC, CHROMECAST2 AUDIO DONGLE no2 POWERED BY ANKER BATTERY PSU - FULL RANGE TWIN & SINGLE TELEFUNKEN's - Q ACOUSTIC BT3 actives - CANTON SUB - TANDBERG TCD310 CASS - CARTS.. ACD xlm mk1 integra, AT95SA Shibata, SHURE N55 SAS, SHURE M55E original, JVC MD1029. - RCA CABLES BY BRIAN SPKR CABLES BY MOI HAIR BY MARCO FEET BY ELECTRICBEACH - MAINS REGENERATED BY POWERINSPIRED AND FILTERED BY BELKIN PUREAV.

  8. #8
    Join Date: Jun 2012

    Location: Portsmouth, UK

    Posts: 80
    I'm Steve.

    Default

    The 30 wpc Pioneer SX-450 has become my receiver of choice!

    It's honestly much better than the Rotel RA-931 I've been using for years.

    Pioneer SX-450.JPG

    The speaker cable grips aren't quite the modern idea of 4mm banana plugs, but work well enough. The tone controls are a delight to boost the bass a tidge with my rather dry speakers. It's good to have a mono button too, just to check polarity and imaging.

    I honestly can't fault it. Amazing that a 30/40 year old receiver can sound so good. Pioneer were genius.

  9. #9
    Join Date: Sep 2012

    Location: East Anglia UK

    Posts: 1,173
    I'm Marc.

    Default

    Quote Originally Posted by dantheman91 View Post
    Well i can now update this thread and say the pot clean worked a treat they are now silent in operation and the amplifier is now - I've set up a little night system with a pair of Mini Technics SB-30 full range speakers & modded Pioneer PDS703 & Pioneer F676 Tuner and is working very well together system for peanuts and sounds this good....

    Not bad going.....

  10. #10
    Join Date: Sep 2009

    Location: Bournemouth

    Posts: 3,980
    I'm Dan.

    Default

    Pictures - Featured are a full set

    Pioneer SA 6300
    Pioneer PDS 703
    Pioneer F-676 Tuner
    Teac LS X8 - Speakers - though currently using Marantz HD-300

    = All in about 15.... thats for everthing.
    Attached Images Attached Images
    Main System: Yamaha CR-820 Receiver & Musical Fidelity E50 Tuner & Pioneer PD S505 Precision CD Player & Mission 770 Freedom Speakers + Linn Interconnects & Van Den Hul The Wind hybrid Speaker Cable
    Vinyl -
    Rega Planer 2 with Rega Britain Green 250 Tonearm & Upgraded Van Den Hul Oil Bearing & Ortofon Super OM-10.

    Second System:
    Technics - SU-C909U Pre-Amplifier & SE-A909S Power Amplifier & Technics ST-GT 1000 Tuner & Marantz CD67 Original SE CD player & Thorens TD-125 MK1 Turntable & SME 3009 Series 1 & Shure V15 Type II Cartridge & SME 2000 Plinth & Celestion A compact Speakers

+ Reply to Thread
Page 1 of 2 12 LastLast



 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •