that would be some really highend diy …
;-)
Michael
Location: Krems/Wachau/Austria/Europe
Posts: 132
I'm Michael.
that would be some really highend diy …
;-)
Michael
I used to have a lovely all-singing Fluke when I was a service engineer. Giving that back was the worst thing about leaving that job.
Plan ahead and put some ducting under the floor so you can pull more wires through later.
The easy and low cost way is to use 32mm or 40mm waste pipe from screwfix etc. ( electrical conduit is too small to pull any extra through)
http://www.screwfix.com/p/solvent-we...3m-white/61967 with smooth corners http://www.screwfix.com/p/floplast-9...ack-of-5/67525
More choices : http://www.screwfix.com/c/heating-pl...ings/cat831524
Location: Exeter
Posts: 93
I'm Paul.
Now why didn't I think of that? Note; rhetorical question, no need for all the very bvious answers!