Search:

They might prove all sides right.

Interesting read.

https://phys.org/news/2017-03-quantum-physics-insight-music.html

Setting the levels is the most important part. Almost any interface comes with a software mixer now. Audacity is fine for that purpose. There are expensive programs, but they are geared towards full...

Streaming it from my phone to the PC improves the quality.

Does Spotify stream a lower bitrate to PCs than mobile devices? It sounds like muddy compressed garbage through my PC, and nearly lossless from my phone using the same DACs.

I don't think it's RF...

Not for me. If I had them on three tables I could pick up speed.

Same here. Swapping headshells takes 5 seconds.

I looks like a top notch system, and it doesn't take up your whole living room. I see the benefits of it. I'm just cheap.

Those are cool, but I could pay someone to do it for what those things cost. There's a lot of gear inside those boxes. I've never seen them before.

I've never seen a list anywhere. It would be nice to have one. I'm always scared when I get one off of eBay.

Nope. Some of the later models had changers like a jukebox. Mine didn't.

The Douk stuff has been pretty good from my experience. The case and heatsink is worth the price. I don't know how they build stuff that cheap.

The Pass kits can be inexpensive to build. Surplus parts, and the patience to test and match Chinese components saves a lot. Most of them are 25 watts.

The real Aleph 2s are the best solid state...

You have to build the correct box for them. I bet they sell some direct replacements for those speakers. They do for most. They have factory replacements for a lot of them.

Some of their cheap speakers are actually really good. I built a line array from some they had on closeout once. It would have been too expensive otherwise. 64 high end drivers would have cost a...

It's nice to have a lazy day every now and then.

Some years we get a ton others we barely get any. It's not really that bad out. I just don't like driving in it because someone runs into me every time.

I don't have a garage here, but I have a...

They're looking good. I have some ARs I was planning on sanding down today but I'm snowed in. Winter decided to make a comeback.

How many coats are you planning on using? I really like the grain on the right one. Those are turning out great.

Beautiful table. I like how you pulled out the grain on it. How did you finish it? Walnut it my favorite too.

That's one of the ones I found.

They all usually work.

I found about ten schematics that are all different. It looks like a lot of people have tried to figure out what's in those things, and haven't been able to recreate it.

I read one article where...

Probably.

I'd like to see what's inside the heatsinks. I was wondering where all of the components were too.