Hi all,
Having setup one of my SL1210 mk2 again I've found that the platter on one of them simply will not remove. Pulling off the other one is no hassle at all.
Has anyone come across this difficulty before and solved it?
Cheers
Printable View
Hi all,
Having setup one of my SL1210 mk2 again I've found that the platter on one of them simply will not remove. Pulling off the other one is no hassle at all.
Has anyone come across this difficulty before and solved it?
Cheers
may have jammed a bit on spindle. try a slight jiggle as you lift or tap spindle a little. had this on a few tts.
Try packing cardboard under the platter rim all round, in order to apply a bit of upward pressure and then tap the spindle/shaft moderately with a hammer, using a piece of wood to protect the spindle tip. That usually works.
Thanks gents, will let you know the outcome. I think the packing will be better here, I pulled and wiggled very hard a number of times! (ooo err).
a gentle tap with a panel pin hammer will work wonders.
Small squirt of WD40 then leave for a while. Then pull up on the platter as someone lightly taps the spindle. Put a cloth over the spindle so you dont mark it.
give the spindle a good knock-knock, preferably with s bit of wood or hard plastic.
Worst case scwenario- hair drier around the spindle and pull
https://www.youtube.com/watch?v=hS1w0hA01go at around the 1 minute mark