hi guys,
I have a new system which I getting used to, and wondered if there is a type of speaker cable which suits particular systems better. I am using a Simaudio Moon Neo Ace al in one and a pair of dynaudio contour s3.4 speakers. So far I tried some old chord epic which I found a bit cold and flat, and now trying some tellurium q black which sounds nicer all round.
I suppose I want to understand if there is a type of cable which I should try based on the systems specs below, as im not too technical.
Simaudio Neo Ace
Configuration Stereo
Power Supply Transformer 250VA
Power Supply Capacitance 20,000μF
Class Of Operation – Amplifier Class A/B
Single-ended inputs 2 (RCA) pairs
Mini-jack input 1 (1/8”)
Input Sensitivity 370mV – 3.0V RMS
Input Impedance 22,100Ω
Preamplifier / Subwoofer output 1 (RCA) pair
Headphone output 1 ( 1/4” Stereo TRS)
Output Power @ 8Ω 50 Watts per channel
Output Power @ 4Ω 85 Watts per channel
Gain 37dB
Signal-to-noise Ratio 100dB @ full power
Frequency Response 10Hz - 80kHz +0/-3.0dB
Crosstalk@ 1kHz -100dB
Intermodulation Distortion 0.005%
Total Harmonic Distortion (20Hz-20kHz @ 1W) 0.02%
Total Harmonic Distortion (20Hz-20kHz @ 50W) 0.02%
Remote Control Full-Function (CRM-3)
Display Type OLED
Power Consumption @ idle 44 watts
Power Consumption @ Standby 11 watts
Dynaudio Contour S3.4
Sensitivity: 86 dB (2,83 V/1 m)
IEC Power Handling: 270 W
Impedance: 4 Ohms
Frequency Response: 35 Hz – 25 kHz (± 3 dB)
Box Principle: 2-way bass-reflex
Crossover Frequencies: 2000 Hz