View Full Version : Yamaha CA 800, Todays boot sale find
Audio Al
04-09-2016, 13:57
:D
It WORKS
Soldered the power lead back in , switched it on and waited for the relay click :eyebrows: " Click "
Switched it to phono stage and speakers A
And we have audio :)
But we also have an annoying HUM :( , Checked the earth and moved from one earth point to the other , It has 2 earth points
Looks like I need to find a sparky to give it a once over :)1793017931179321793317934
Not found the resident spider yet , its hiding or dead :)
Audio Al
04-09-2016, 13:58
179351793617937More photos
Its a dusty on bin ...least its a workin,
walpurgis
04-09-2016, 14:50
That should be really nice once you get it set up right Al.
Audio Al
04-09-2016, 14:54
That should be really nice once you get it set up right Al.
I do hope so Geoff , Fingers crossed :)
A friend has one, set permanently to Class A. Doesn't run too hot this way and does sound great - I heard it at easter, so a fresh memory..
I was given a CA1000mk2 some years back that I sold originally when new. I was less impressed with the preamp section (so much internal wiring between all those sub-boards), but again, the Class A setting was sublime.
Audio Al
04-09-2016, 19:57
I emailed a service sheet to a good friend of mine who was / is a electronics engineer ( now retired ) he informs me that it should have a 3 core cable with a earth going to the chassis , The one that was shoved into the chassis is only 2 core , may cure the hum , I won't switch it o again until this is rectified :)
walpurgis
04-09-2016, 20:00
Bet it works.
Audio Al
04-09-2016, 20:04
Bet it works.
Will find out tomorrow ;)
The selector is not switched to phono (MM/MC) if so it might buzz without anything connected.
Audio Al
04-09-2016, 20:11
The selector is not switched to phono (MM/MC) if so it might buzz without anything connected.
Hi Rob
It was connected via the phono stage
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.