Magna Audio
11-06-2015, 13:12
This one is bound for Singapore.
The brief was to make a armlift and rest holder to fit the lovely ATP-12t (a 10.5 inch arm), this time it had to be as short as possible to allow maximum range / travel of the arm tube slider weight.
Hewn and then fine milled out of 6mm plate Stainless Steel and then polished to match the arm / the chromed Jelco armlift that was was supplied to match.
Both the arm lift and rest are height adjustable the latter also position adjustable.
https://uploads.tapatalk-cdn.com/20171007/4a2cf105762932e8c54f7df6d09c1eee.jpg
Shaped, tapped, polished and fitted out
https://uploads.tapatalk-cdn.com/20171007/fdecfc27034a667e2581d7745750941f.jpg
Testing with dummy armtube
https://uploads.tapatalk-cdn.com/20171007/64b239e4e32634b683a41abae5d8a894.jpg
The counterweight required to balance SPUs was 200g.
This was also made of Stainless Steel, shaped to match the original and polished. A thumbscrew was chosen instead of a grub screw
Cutting the thumbscrew thread
Drilling the weight, a nylon inner damping sleeve will be fitted.
Weight checked
the finished article
If you have a project or 'special' engineering need required to create a solution, just contact me.
The brief was to make a armlift and rest holder to fit the lovely ATP-12t (a 10.5 inch arm), this time it had to be as short as possible to allow maximum range / travel of the arm tube slider weight.
Hewn and then fine milled out of 6mm plate Stainless Steel and then polished to match the arm / the chromed Jelco armlift that was was supplied to match.
Both the arm lift and rest are height adjustable the latter also position adjustable.
https://uploads.tapatalk-cdn.com/20171007/4a2cf105762932e8c54f7df6d09c1eee.jpg
Shaped, tapped, polished and fitted out
https://uploads.tapatalk-cdn.com/20171007/fdecfc27034a667e2581d7745750941f.jpg
Testing with dummy armtube
https://uploads.tapatalk-cdn.com/20171007/64b239e4e32634b683a41abae5d8a894.jpg
The counterweight required to balance SPUs was 200g.
This was also made of Stainless Steel, shaped to match the original and polished. A thumbscrew was chosen instead of a grub screw
Cutting the thumbscrew thread
Drilling the weight, a nylon inner damping sleeve will be fitted.
Weight checked
the finished article
If you have a project or 'special' engineering need required to create a solution, just contact me.