vencel
14-03-2012, 22:00
Hello,
I am in the process of changing (again and finally) the wires in my Lancasters between the crossover and the speaker and would like to use a thinner wire for the HF and a thicker for the LF unit and for this I need to know which color goes to the HF and LF and the 4pin connector layout.
There are only 3 wires (red, green and black) from which I believe the black is the common negative, so either the red or the green one is the LF wire.
In the meantime I received an answer from forum members so I would like to share it with everybody:
http://dl.dropbox.com/u/22181492/redxover2.jpg
http://dl.dropbox.com/u/22181492/MG_HPD_Pinout.jpg
I would still appreciate if anybody could confirm it.
I hope this information will be useful for others as well.
Thanks and regards,
László
I am in the process of changing (again and finally) the wires in my Lancasters between the crossover and the speaker and would like to use a thinner wire for the HF and a thicker for the LF unit and for this I need to know which color goes to the HF and LF and the 4pin connector layout.
There are only 3 wires (red, green and black) from which I believe the black is the common negative, so either the red or the green one is the LF wire.
In the meantime I received an answer from forum members so I would like to share it with everybody:
http://dl.dropbox.com/u/22181492/redxover2.jpg
http://dl.dropbox.com/u/22181492/MG_HPD_Pinout.jpg
I would still appreciate if anybody could confirm it.
I hope this information will be useful for others as well.
Thanks and regards,
László